back to the Dollhouse Workshop
  • This is how the Attic Partition and the Partition Extension work together to make a Dormer Partition. I'm not assembling it now... just checking
    950_dormer_0...
  • I am holding the Dormer Front against the Dormer Partition to review how the bevels work. Doing this identifies the outside of the Dormer Front
    950_dormer_0...
  • Shingle Guidelines: starting with "one shingle length"
    950_dormer_0...
  • Shingle Guidelines: the rest of the spacing is 1"
    950_dormer_0...
  • Drawing Shingle Guidelines
    950_dormer_0...
  • Extending the guidelines around the corner
    950_dormer_0...
  • Now the Dormer Front is face-down; I am lining up the Side with the Front at the bottom edge. I am locating the Dormer Side in order to transfer the guideline spacing from the Front to the Side
    950_dormer_0...
  • Transferring Guidelines
    950_dormer_0...
  • Using the Divider as a "square" to draw straight lines on the Dormer Side
    950_dormer_0...
  • These Guidelines will line up the shingles on the Sides with the Shingles on the Front
    950_dormer_0...
  • Preparing flaps of tape
    950_dormer_0...
  • Gluing and taping the Sides to the Front. They are lined up at the bottom and top
    950_dormer_1...