back to the Dollhouse Workshop
  • These are the Interior Door trim, the Hinge & Nail pack, the Door Panel, and the Threshold
    950_door_01....
  • The Hinges will be on the inside edge of the Door Panel. The Hinges are folded to keep them straight while nailing
    950_door_02....

  • 950_door_03....
  • The house is lying on its front on a firm pounding surface. I am gluing on the Interior Trim lined up with the door cutout's edge. I'll fine-tune the Vertical trim's position with the Threshold (un-glued) between them.
    950_door_04....
  • On the outside of the door, a pilot hole for the Knob...
    950_door_05....
  • ...don't drive the nail all the way thru
    950_door_06....
  • I am driving in the knob. I'll turn it the last bit with plyers
    950_door_07....
  • The hinges are flat on the Interior Trim, the spaces are even top-to-bottom and side-to-side.
    950_door_08....
  • If you can't get the nail to stand up, push it thru a card first
    950_door_09....
  • Driving the Hinge-Nails... now you can see why this comes before installing the dividers
    950_door_10....
  • On the outside, this is how the Step, the Door Base, and the Threshold look. They are all centered on the door.
    950_door_11....
  • This block of stone is a bookend when it's not giving me a solid locater for the Front Step
    950_door_12....