back to the Dollhouse Workshop
  • Organize the stripwood by size. The 1/2 x 1/8 stripwood is thicker than the rest of the 1/2" stripwood... it's as thick as the 1" stripwood
    1065trim_01....
  • Lay the ruler on the diagram exactly lined up with the angled end of the trim
    1065trim_02....
  • Extend the trim's end-line up and down to make an "angle tracing guide"
    1065trim_03....
  • Lay a piece of 1" trim on the diagram exactly lined up with the diagram's 1" trim
    1065trim_04....
  • Line up the ruler with the angle tracing guide and mark the angle on the trim
    1065trim_05....
  • Find the angle on the Attic Partition that lines up with the angle mark
    1065trim_06....
  • Use the edge of the Attic Partition to guide the saw as you cut the angle
    1065trim_07....
  • Measure the 12 1/16 for the length of the eave trim - don't use the diagram for this length... it prints a different length every time.
    1065trim_10....

  • 1065trim_11....
  • Extend the diagram's base line for a base "angle guide"
    1065trim_12....
  • Put the trim on the diagram with the 12 1/16 mark at the base angle tracing guide line
    1065trim_13....
  • Mark the angle on the trim
    1065trim_14....