back to the Dollhouse Workshop
  • The 2" piece of stripwood will make a support for the Junction Splice. Locate it with the tapewire flap
    100.jpg
  • I am scribing around the support block with a craft knife
    101.jpg
  • 3 sides.
    102.jpg
  • I have not cut deeply, just enough to mark the edges
    103.jpg
  • I used the rounded part of a jack knife to scrape the tips off the clapboard. I want the support block to be touching the wall in the center where the junction splice's screw will will go thru the support block and into the wall
    104.jpg
  • Plenty of glue
    105.jpg
  • Confirm the location again
    106.jpg
  • And clean up the excess glue. A clamp is good if you have it, but be gentle.
    107.jpg
  • Lined, straight, and flat.
    108.jpg
  • Trim the tapewire at the end of the support block
    109a.jpg
  • and paint with the housebody color
    109b.jpg