Plogger Photo Feed: Housebody Album

Lay the house on its back, weight the Mid Floor. Let the glue dry

Tue, 23 Sep 2008 21:16:55 -0400

Lay the house on its back, weight the Mid Floor. Let the glue dry

Tue, 23 Sep 2008 21:16:54 -0400

A Divider above and below the Mid Floor locates the Mid Floor while the glue dries

Tue, 23 Sep 2008 21:16:53 -0400

Tape the Front to the Top Floor. Keep the Sides tight with a long band of tape just above the Front

Tue, 23 Sep 2008 21:16:52 -0400

Tape up the Side lining up the house as-you-go

Tue, 23 Sep 2008 21:16:50 -0400

Tape across the base lining up the Base Floor carefully

Tue, 23 Sep 2008 21:16:50 -0400

Set on the Front holding the corners in place so the glue stays in the joint

Tue, 23 Sep 2008 21:16:49 -0400

Glue on all the front edges

Tue, 23 Sep 2008 21:16:48 -0400

Let the glue stiffen but not dry... the Front is the thing that truelly squares the house (the Divider helps, but the Front is much bigger)

Tue, 23 Sep 2008 21:16:47 -0400

tape... tightly stretched.

Tue, 23 Sep 2008 21:16:45 -0400

Glue on the end of the floor... careful again so the glue stays in the groove

Tue, 23 Sep 2008 21:16:44 -0400

Set the Base Floor in the groove carefully to keep the glue in the groove

Tue, 23 Sep 2008 21:16:41 -0400

Put glue in the Base Floor's groove

Tue, 23 Sep 2008 21:16:39 -0400

Press or tap it to make the wall smooth

Tue, 23 Sep 2008 21:16:38 -0400

There's already glue in the groove

Tue, 23 Sep 2008 21:16:36 -0400

Tidy up the edges of the Groove Fill