Installing fixture adaptors
CK3717 plus Adapter and Spring-Loaded Eyelets come together when purchased from Real Good Toys
01D.png
There's no clearance in this light's base so I drilled out the adaptor to give room for the wire
DremelD.jpg
Press the wire against the Adapter so you don't pull on the fixture at all
../CK3384/07D.png
... pinch (separate a bit of the insulation - maybe 1/4 to 1/3 of an inch)
../CK3384/13D.png
... because they show really well the "a bit at-a-time" series for taking off insulation
../CK3384/16D.png
Insert the twisted, trimmed wires into the tubes (I need magnifiers to see them)
24D.png
- Test the light before you start (tighten bulbs if necessary)
- Re-test along the way
- Inspect the fit of the adapter to know how much lacquer to sand
- Complete the plug before gluing it on
- Pinch the insulation off a bit at-a-time
- Spin the last insulation bit as you pull it off to twist the wire